The impact resistant facing board complies with the performance requirements of Class O of the Building Regulations, is incombustible to BS 476 part 4, and is rated Class 1 Surface Spread of Flame to BS 476 part 7.
AIM UPSTAND BOARD – DOW XPS FOAM
AIM XPS Insulated Upstand Boards are manufactured from an extruded polystyrene foam bonded to our external grade high impact facing board. They are used to provide thermal insulation to the parapet walls in inverted roof systems
- Standard Size: 1200 x 600mm*
- Thickness: 56mm (50mm STYROFOAM XPS foam + 6mm facing board)**
- Tensile Bond Strength (TBS) testing in accordance with test method EN 1607
- 300 cycle Freeze / Thaw action tested to EN 12091-97 cycling between -20 to +20 degrees centigrade
- Compressive strength of extruded polystyrene ‘STYROFOAM XPS foam’ is 300kPa
- Facing board is highly resistant to impact damage and offers an extremely robust finish
- Thermal conductivity: Extruded polystyrene ‘STYROFOAM XPS foam’ is 0.035W/mK; facing board is 0.47W/mK; (R Value) of 56mm board is 1.44m2K/W
*Can be supplied in other sizes to suit customer requirements
** Other thicknesses available on request
The boards should be cut using a TCT saw (ensure that FFP2 or 3 grade PPE is used to protect against inhalation of dust during cutting). The board should be fixed directly to the upstand wall using the recommended through fixings. Fixing centres should not exceed 600mm. Fixings should be positioned at least 50mm from the top of the facing board, but should not exceed 200mm. In the event that a roof deck is not supporting the bottom of the board, additional through mechanical fixings should be used to compensate.
AIM recommends Speedline DDS fixings or similar approved when installing this product. Ensure that the fixings are a minimum of 25mm longer than the overall thickness of the board. These are available from SIG Fixings and other approved distributors.
Where required the facing board may be painted without any special priming using an alkali resistant paint or emulsion. Two coats of paint will usually give a satisfactory finish. Suitable paints are: Acrylics, Chlorinated rubber, Epoxy, PVA, PVC, Polyurethane and silicate.